| Ti微合金化对3.5Ni钢低温韧性的影响 |
| |
| 作者姓名： | 李建华 吴开明 邱金鳌 |
| |
| 作者单位： | 武汉科技大学国际钢铁研究院;武汉钢铁(集团)公司研究院 |
| |
| 基金项目： | 国家自然科学基金重点项目(50734004) |
| |
| 摘 要： | 利用光学显微镜和透射电镜观察不同Ti含量3.5Ni钢试样的组织及析出物,并通过测定其-80～-120℃的夏比冲击功来研究Ti微合金化对3.5Ni钢低温韧性的影响。结果表明,与0.042Ti试样相比,0.079Ti试样在热轧态和正火+回火态时晶粒大小相同,但其热轧态组织中珠光体细化,且正火+回火态组织中TiN数量增多,平均尺寸约为150nm;正火+回火处理后,0.079Ti试样在-80～-120℃的夏比冲击功为233～23J,均低于0.042Ti试样相应值(234～66J);对于正火+回火态试样,较粗大TiN粒子的析出是造成其低温韧性降低的主要原因。
|
| 关 键 词： | 3.5Ni钢 Ti微合金化 珠光体 TiN 低温韧性 |
| 收稿时间： | 2011/10/31 0:00:00 |
Effect of Ti miroalloying on the low temperature toughness of 3.5Ni steel |
| |
| Institution: | Li Jianhua1,2,Wu Kaiming1,Qiu Jin’ao1 (1.International Research Institute of Steel Technology,Wuhan University of Science and Technology,Wuhan 430081,China;2.Research and Development Center,Wuhan Iron and Steel Corporation,Wuhan 430080,China) |
| |
| Abstract: | The effect of Ti microalloying on the toughness of the cryogenic pressure vessel 3.5Ni steel was investigated by examining the microstructure and precipitates of the steel using optical microscopy and transmission electron microscopy and by measuring the charpy impact energy from-80 ℃ to-120 ℃.The results show that the steel containing 0.079% Ti has the same average grain size with the steel containing 0.042% Ti,but has fewer pearlite in the as-rolled steel and more coarse TiN particles(the average size about 150 nm) in the normalized and tempered steel than the latter.The charpy impact energy of the steel containing 0.079% Ti has a lower level(233~23 J) than that of the steel containing 0.042% Ti(234~66 J).In the normalized and tempered steel,a large number of coarse TiN results in a decrease in the low temperature toughness. |
| |
| Keywords: | 3 5Ni steel Ti microalloying pearlite TiN low temperature toughness |
| 本文献已被 CNKI 等数据库收录！ |
| 点击此处可从《》浏览原始摘要信息 |
| 点击此处可从《》下载免费的PDF全文 |
|
