| 光耦隔离晶闸管交流调压电路过触发现象研究 |
| |
| 引用本文： | 吕平一,于勇,要林伟,陈亚东,陈思瑶.光耦隔离晶闸管交流调压电路过触发现象研究[J].科技资讯,2014(33):90-91. |
| |
| 作者姓名： | 吕平一 于勇 要林伟 陈亚东 陈思瑶 |
| |
| 作者单位： | 大连东软信息学院; |
| |
| 基金项目： | Supported by Dalian Science and Technology Fund,2013J21DW005 |
| |
| 摘 要： | 该文分析了晶闸管三相交流调压光耦隔离驱动电路中的过触发现象,即以自然换相点为起点,当触发脉冲大于120时,输出电压有效值可能骤然增加的现象。过触发现象可能造成异步电机失控,从而带来破坏性影响。该文通过理论分析、仿真及实验,分析了过触发现象的原因,并给出了避免过触发现象的控制方法。
|
| 关 键 词： | 晶闸管 光耦隔离 过触发 |
Research on Over Trigger for Opto-lsolatedThyristor |
| |
| Institution: | AC-Voltage Regulator Dalian Neusoft University of Information,Dalian 116023,China |
| |
| Abstract: | This paper analyzes over trigger phenomenonfor opto--isolated thyristor AC-voltage regulator,which meansfrom the starting point（natural phase change point）, when trigger pulseis greater than 120.7, the output voltage RMS may suddenly increase. Over trigger may cause out of control on asynchronous motors, leading to devastating effects.By theoretical analysis, simulationand experiments,this article analyzes the causes of the over trigger phenomenon, and gives control methods to avoid it. |
| |
| Keywords: | Thyristor Opto--Isolated Over trigger |
| 本文献已被 CNKI 维普 等数据库收录！ |
|
