| 超高速充液旋压时轴向拉力和断管分析 |
| |
| 引用本文： | 汤勇,王莉,周德明,张娟,王威,夏伟.超高速充液旋压时轴向拉力和断管分析[J].华南理工大学学报(自然科学版),2001,29(4):13-16. |
| |
| 作者姓名： | 汤勇 王莉 周德明 张娟 王威 夏伟 |
| |
| 作者单位： | 华南理工大学机电工程系, |
| |
| 基金项目： | 国家自然科学基金资助项目! (5 970 5 0 16 )，广东省自然科学基金资助项目! (95 0 2 2 2 ) |
| |
| 摘 要： | 系统分析了超高速充液旋压内螺旋翅片过程中轴向拉力和断管倾向 .改善入口模区和旋压区管内 (外 )润滑条件 ,优化入口模和挡头结构 ,精确控制旋压量大小是减少轴向拉力及其断管倾向的主要措施 .旋压量增大时轴向拉力增大 ,当旋压量超过临界值时轴向拉力随旋压量增加而急剧增大 .入口模锥角对轴向拉力的影响十分明显 ,在入口模锥角13°时 ,轴向拉力最小 ,随着入口模锥角的增大或减少 ,轴向拉力均会增大 .
|
| 关 键 词： | 充液旋压 超高速 内螺旋翅片铜管 轴向拉力 断管倾向 旋压量 旋压挤压 |
| 文章编号： | 1000-565X(2001)04-0013-04 |
| 修稿时间： | 2000年6月3日 |
The Analysis of the Axial Drawing Loads and Breakage During Oil_Filled Spinning at Superspeed |
| |
| Tang Yong,Wang Li,Zhou De_ming,Zhang Juan,Wang Wei,Xia Wei.The Analysis of the Axial Drawing Loads and Breakage During Oil_Filled Spinning at Superspeed[J].Journal of South China University of Technology(Natural Science Edition),2001,29(4):13-16. |
| |
| Authors: | Tang Yong Wang Li Zhou De_ming Zhang Juan Wang Wei Xia Wei |
| |
| Abstract: | This paper systematically studies the axial drawing loads as well as the tendency of breakage during oil_filled spinning at superspeed. The axial drawing loads and the tendency of breakage can be reduced mainly by improving the lubrication conditions in the entry din and the spinning zone, optimizing the structures of the entry din and the stopper and exactly controlling spinning reduction. The axial drawing loads increased with the rise of spinning reduction, and increased sharply while exceeding critical spinning reduction. The entry din semi_angle has great influence on the axial drawing loads. The smallest value was obtained when the entry din semi_angle is 13°. If the entry din semi_angle was bigger or smaller than 13°, the axial drawing loads would increase. |
| |
| Keywords: | oil_filled spinning superspeed inner spiral fin copper tube |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
