| Cr3C2颗粒增强型堆焊合金组织与性能分析 |
| |
| 引用本文： | 郑丽娟,刘会莹,付宇明,韩晓娟.Cr3C2颗粒增强型堆焊合金组织与性能分析[J].燕山大学学报,2012,36(4):324-327. |
| |
| 作者姓名： | 郑丽娟 刘会莹 付宇明 韩晓娟 |
| |
| 作者单位： | 燕山大学机械工程学院,河北秦皇岛,066004 |
| |
| 基金项目： | 国家自然科学基金资助项目 |
| |
| 摘 要： | 对加入Cr3C2的药芯焊丝制备的Cr3C2增强型堆焊合金组织和性能进行了分析。添加Cr3C2的自保护药芯焊丝堆焊工艺性能良好,堆焊表面少飞溅,无裂纹气孔。通过对比实验研究发现,加入Cr3C2的药芯焊丝制备的Cr3C2增强型堆焊合金组织细小,高温冲击韧性明显优于WC颗粒增强型药芯焊丝,合金组织中既有颗粒增强型药芯焊丝堆焊产生的颗粒增强相,又有高铬铸铁型药芯焊丝堆焊产生的高硬度初生碳化物,双重强化机制使堆焊层显微硬度达到含Nb高铬铸铁堆焊层的水平,平均硬度60 HRC以上。
|
| 关 键 词： | Cr3C2颗粒 自保护药芯焊丝 堆焊合金 组织分析 |
Analysis on microstructure and performance of Cr3C2 enhanced surfacing welding alloy |
| |
| ZHENG Li-juan
,
LIU Hui-ying
,
FU Yu-ming
,
HAN Xiao-juan.Analysis on microstructure and performance of Cr3C2 enhanced surfacing welding alloy[J].Journal of Yanshan University,2012,36(4):324-327. |
| |
| Authors: | ZHENG Li-juan LIU Hui-ying FU Yu-ming HAN Xiao-juan |
| |
| Institution: | (College of Mechanical Engineering,Yanshan University,Qinhuangdao,Hebei 066004,China) |
| |
| Abstract: | The microstructure and performance of Cr3C2 enhanced surfacing welding alloy are analyzed.Self shielded flux-cored wire which contains Cr3C2 particles has a good welding performance.Welding surface has fewer spatters,especially no crack and holes.Comparison test analysis has found that the microstructure of Cr3C2 enhanced self shielded flux-cored wire surfacing layer is fine and smooth.Besides,its impact toughness is better than WC self shielded flux-cored wire.Cr3C2 enhanced surfacing layer contains not only Cr3C2 particles,but also high hardness primary carbide which produced by high chromium cast iron flux-cored wire welding.Therefore,surfacing layer has the very high micro hardness and the average value exceeds 60 HRC,which is same with Nb enhanced flux-cored wire. |
| |
| Keywords: | Cr3C2 particles self shielded flux-cored wire surfacing welding alloy microstructure analysis |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
