| 用可编程控制器改造Y5132插齿机 |
| |
| 引用本文： | 薛昭武. 用可编程控制器改造Y5132插齿机[J]. 福州大学学报(自然科学版), 1997, 0(1): 64-67 |
| |
| 作者姓名： | 薛昭武 |
| |
| 作者单位： | 福州大学机械工程系 |
| |
| 摘 要： | 介绍用可编程控制器（ＰＬＣ）改造插齿机的原理和方法．分析了插齿机切削运动，给出电气系统设计，ＰＬＣ编程方法以及部分梯形图
|
| 关 键 词： | 可编程控制器 插齿机 梯形图 液压传动 |
Modification of Y5132 Gear Shaper by the Programmable Controller |
| |
| Xue Zaowu. Modification of Y5132 Gear Shaper by the Programmable Controller[J]. Journal of Fuzhou University(Natural Science Edition), 1997, 0(1): 64-67 |
| |
| Authors: | Xue Zaowu |
| |
| Affiliation: | Xue Zaowu (Department of Mechanical Engineering, Fuzhou University, Fuzhou, 350002) |
| |
| Abstract: | The paper deals with the principle and method of modifing the gear shaper by the programmable controller(PLC). The design of electrical system, the PLC programming method and the partial ladder figure are obtained by analyzing the cutting motion of the gear shaper. |
| |
| Keywords: | programmable controller gear shaper ladder figure hydromatic drive |
| 本文献已被 CNKI 等数据库收录！ |
| 点击此处可从《福州大学学报(自然科学版)》浏览原始摘要信息 |
|
点击此处可从《福州大学学报(自然科学版)》下载免费的PDF全文 |
