| CaO-SiO2-Al2O3-MnO系低熔点区域控制 |
| |
| 引用本文： | 金利玲,王海涛,许中波,王福明.CaO-SiO2-Al2O3-MnO系低熔点区域控制[J].北京科技大学学报,2007,29(6):574-577. |
| |
| 作者姓名： | 金利玲 王海涛 许中波 王福明 |
| |
| 作者单位： | 北京科技大学冶金与生态工程学院,北京,100083 |
| |
| 摘 要： | 通过热力学计算软件FactSage计算分析了CaO-SiO2-Al2O3-MnO四元系夹杂物低熔点区域的控制范围. 从控制夹杂物成分的角度,指出随着Al2O3含量和CaO含量的增加,夹杂物低熔点区域大小都是先增大后减小;随着SiO2含量和MnO含量的增加,夹杂物低熔点区域增大. 为了得到低熔点夹杂物,应控制SiO2-Al2O3-CaO-MnO系中Al2O3质量分数为20%左右,CaO质量分数在25%～30%之间;同时控制CaO/SiO2比值为0.8～1,SiO2质量分数应为30%左右.
|
| 关 键 词： | 炼钢 CaO-SiO2-Al2O3-MnO系 热力学计算 夹杂物 成分控制 低熔点夹杂物 域控制 system area melting point 比值 质量分数 大小 含量 成分 控制范围 区域 四元系 计算分析 计算软件 热力学 |
| 修稿时间： | 2006-02-122006-08-13 |
Control on low melting point area in a CaO-SiO2-Al2O3-MnO system |
| |
| JIN Liling,WANG Haitao,XU Zhongbo,WANG Fuming.Control on low melting point area in a CaO-SiO2-Al2O3-MnO system[J].Journal of University of Science and Technology Beijing,2007,29(6):574-577. |
| |
| Authors: | JIN Liling WANG Haitao XU Zhongbo WANG Fuming |
| |
| Institution: | Metallurgical and Ecological Engineering School, University of Science and Technology Beijing, Beijing 100083, China |
| |
| Abstract: | The compositions of low melting point inclusions in a CaO-SiO2-Al2O3-MnO system were calculated and analyzed by thermodynamic software FactSage. The results show that the area of low melting point inclusions first increases then decreases with the alumina and calcium oxide contents accumulating. However, it always increases with the silica and manganese oxide contents rising. To obtain low melting point inclusions, the alumina and silica contents should be approximately controlled to 20 % and 30 %, respectively, the CaO content restricted to 25% -30%, and CaO/SiO2 should be 0.8- 1. |
| |
| Keywords: | steelmaking CaO-SiO2-Al2O3-MnO system thermodynamic computation inclusions composition control |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
