首页 | 本学科首页   官方微博 | 高级检索  
     

宽板坯连铸结晶器内液面波动的数值模拟
引用本文:刘国林,吴苏州,张炯明,王万军,王新华. 宽板坯连铸结晶器内液面波动的数值模拟[J]. 北京科技大学学报, 2009, 31(2)
作者姓名:刘国林  吴苏州  张炯明  王万军  王新华
作者单位:北京科技大学冶金与生态工程学院,北京,100083
基金项目:国家自然科学基金资助项目(No.50674013)
摘    要:以安钢宽板坯连铸为研究对象,采用大型商业软件ANSYSCFX10.0,应用VOF法重点研究浸入式水口倾角、拉速、铸坯断面宽度等工艺参数对结晶器内自由表面液面波动的影响.结果表明:随着结晶器宽度从1800mm增大到3250mm,结晶器内液面平均波高明显降低.当宽度为1800mm时,结晶器保护渣-钢液界面平均波高为5.33mm;当宽度增至3250mm时,平均波高为7.08mm.

关 键 词:结晶器  浸入式水口  液面波动  数值模拟  

Numerical simulation on the surface fluctuation of molten steel in a wide slab continuous casting mold
LIU Guo-lin,WU Su-zhou,ZHANG Jiong-ming,WANG Wan-jun,WANG Xin-hua. Numerical simulation on the surface fluctuation of molten steel in a wide slab continuous casting mold[J]. Journal of University of Science and Technology Beijing, 2009, 31(2)
Authors:LIU Guo-lin  WU Su-zhou  ZHANG Jiong-ming  WANG Wan-jun  WANG Xin-hua
Abstract:The effect of the angle of submerged entry nozzles,casting speed,and cross-section width of slabs on the surface fluctuation in a mold of Anyang Iron & Steel was researched with the VOF model of commercial software ANSYS CFX10.0.The results show that with the mold width increasing from 1 800 mm to 3 250 mm,the average wave height of liquid level in the mold decreases significantly.When the width is 1 800 mm,the average wave height of the mold flux-molten steel interface is 5.33 mm;when the width is 3 250 mm...
Keywords:
本文献已被 CNKI 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号