| PCBN铣刀硬加工时切削用量的选择 |
| |
| 引用本文： | 杜国臣.PCBN铣刀硬加工时切削用量的选择[J].潍坊学院学报,2005,5(6):9-10,16. |
| |
| 作者姓名： | 杜国臣 |
| |
| 作者单位： | 潍坊学院,山东,潍坊,261061 |
| |
| 摘 要： | 通过试验分析研究,介绍了PCBN铣刀硬加工Cr12MoV等淬火钢材料时切削用量对刀具寿命的影响,给出了PCBN刀具铣削淬火钢时切削用量及刀具磨钝标准的选用原则和范围.
|
| 关 键 词： | PCBN铣刀 淬火钢 硬加工 切削用量 刀具寿命 |
| 文章编号： | 1671-4288（2005）06-0009-02 |
| 收稿时间： | 2005-09-12 |
| 修稿时间： | 2005年9月12日 |
Correct Selection of Cutting Parameters during Hard Machining with PCBN End Milling Cutters |
| |
| DU Guo-chen.Correct Selection of Cutting Parameters during Hard Machining with PCBN End Milling Cutters[J].Journal of Weifang University,2005,5(6):9-10,16. |
| |
| Authors: | DU Guo-chen |
| |
| Abstract: | This paper introduces the relations hip between tool life and cutting parameters during milling hardened steel (such as Cr12MoV) with PCBN end milling cutters. By the cutting test and stud y. The principle and range for choosing cutting parameters and tool blunt criterion are recommended. |
| |
| Keywords: | PCBN end milling cutter hardened steel Hard Machining cutting parameter tool life |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
