螺栓连接大变形梁非线性振动特性的实验研究

柔性机械臂、大型可展开天线等机械结构的动作精度受运动过程中大变形几何非线性和连接处接触非线性的影响十分显著。以含螺栓连接结构的大变形梁作为研究对象，针对动力学建模和振动特性开展了实验研究，通过数值计算验证了实验发现的非线性振动特性。搭建了含螺栓连接柔性大变形梁的实验台架，开展了敲击和正弦激振的实验测试。实验结果表明，螺栓连接的柔性梁较连续梁的（无螺栓连接）模态频率降低，阻尼增加，反映出随着激励能量增大，模态频率降低的非线性模态特征。改变螺栓连接位置会显著影响结构的模态频率，其变化规律可由求解线性矩阵特征值定性反映。     

浅谈铁和碱反应

文献［１～６］报道：“铁同强碱不发生作用”．我们用干燥的铁粉和氢氧化钠进行实验．实验证明：铁能跟强碱反应，反应的化学方程式为     

多点柔性墩连续顶推技术在梁桥中的应用

结合工程施工实践,介绍了多点柔性墩连续顶推施工技术.     

结合梁剪力连接件剪拔受力的非线性分析

探讨了结合梁剪力连接件在复杂受力情况下的非线性分析模式与分析方法，计算结果与剪拔试验模型实测结果吻合良好。在此基础上，计算了广州内环中山一路结合梁剪力连接件的受力行为，为设计单位提供了设计参数。     

托梁换柱技术在某砖混结构住宅改造中的应用

介绍了某砖混结构的住宅在旧城区改造过程中,运用托梁换柱的技术,将底层外墙拆除,改建为商铺的设计、施工等情况.     

气相Lys分子体系捕获双电子单重激发态的特性

采用密度泛函理论（DFT）中的B3LYP方法, 在6-311+G(2df)基组水平上, 对气相赖氨酸（Lys）分子和Lys^2-的基态稳定构型进行优化, 并用含时密度泛函理论（TD DFT)方法考察气相Lys分子和带电离子体系单重激发态的特性. 结果表明： Lys分子体系捕获双电子时, 其体系能量有所增加； S1单重激发态与S0基态能量差值变小； 分子体系的荧光波长增加； S7单重激发态跃迁轨道数减少.     

激光光束质量的评价方法

激光光束质量是一个很有现实意义的论题，对不同应用的激光光束其质量的评价标准一般不同。给出了几种有代表性的激光光束质量的评价方法，并分别对各种评价标准的合理性与适用性进行了详细的分析；研究了实际应用中对激光光束质量的一些要求和相关的评价参数。     

Influence of Microstructure and Sintering Routes on Transport Properties of Apatite Materials for Fuel Cells

1 Results Oxy-apatite materials are thought as zirconia-substitutes in Solid Oxide Fuel Cells due to their fast ionic conduction. However, the well known difficulties related to their densification prevent them from being used as such. This study presents strategies to obtain oxy-apatite dense materials and the influence of elaboration route on transport properties. Particular emphasis is put on the microstructure effect on ion conduction. By the combined use of freeze-drying and conventional or spark p...     

Design and passive analysis of a novel softness display device

Simulating the softness property of object is quite a challenge in virtual reality system. A novel softness display system was developed based on the principle of deformable length of elastic element control （DLEEC）. In the system, the equivalent stiffness of the device is adjustable, and is inversely proportional to the third power of the deformable length of elastic beam. PD position control is employed to guarantee the accurate softness display. The softness of the virtual objects in large scale can be felt with the softness display device. Compared with other haptic devices, the device is passive and exert the react force only when the operator ＂actively touch＂ the virtual objects. The stability of the softness display system was analyzed. It was theoretical proved that the system satisfied the criteria of wide impedance range ＂Z-width＂, and the performance was superior to an active system. The experimental results were presented.     

梯形水平折梁的内力分析

本文对梯形水平折梁（０≤α＜∏２）和矩形水平折架（α＝∏２）用最小余能原理进行了内力分析，并导出了相应的计算公式，可在工程结构设计中采用