Cu-Zn-Al2O3 nanocomposites:study of microstructure,corrosion,and wear properties

Alumina nanoparticles were added to a Cu-Zn alloy to investigate their effect on the microstructural, tribological, and corrosion properties of the prepared alloys. Alloying was performed using a mixture of copper and zinc powders with 0vol% and 5vol% of α-Al nanopowder in a satellite ball mill. The results showed that the Cu-Zn solid solution formed after 18 h of mechanical alloying. The mechanically alloyed powder was compacted followed by sintering of the obtained green compacts at 750℃ for 30 min. Alumina nanoparticles were uniformly distributed in the matrix of the Cu-Zn alloy. The tribological properties were evaluated by pin-on-disk wear tests, which revealed that, upon the addition of alumina nanoparticles, the coefficient of friction and the wear rate were reduced to 20% and 40%, respectively. The corrosion properties of the samples exposed to a 3.5wt% NaCl solution were studied using the immersion and potentiodynamic polarization methods, which revealed that the addition of alumina nanoparticles reduced the corrosion current of the nanocomposite by 90%.     

Energy consumption of electrooxidation systems with boron-doped diamond electrodes in the pulse current mode

A pulse current technique was conducted in a boron-doped diamond (BDD) anode system for electrochemical wastewater treatment. Due to the strong generation and weak absorption of hydroxyl radicals on the diamond surface, the BDD electrode possesses a powerful capability of electrochemical oxidation of organic compounds, especially in the pulse current mode. The influences of pulse current parameters such as current density, pulse duty cycle, and frequency were investigated in terms of chemical oxygen demand (COD) removal, average current efficiency, and specific energy consumption. The results demonstrated that the relatively high COD removal and low specific energy consumption were obtained simultaneously only if the current density or pulse duty cycle was adjusted to a reasonable value. Increasing the frequency slightly enhanced the COD removal and average current efficiency. A pulse-BDD anode system showed a stronger energy saving ability than a constant-BDD anode system when the electrochemical oxidation of phenol of the two systems was compared. The results prove that the pulse current technique is more cost-effective and more suitable for a BDD anode system for real wastewater treatment. A kinetic analysis was presented to explain the above results.     

Cu-Zn-Al2O3 nanocomposites: study of microstructure,corrosion, and wear properties

Alumina nanoparticles were added to a Cu-Zn alloy to investigate their effect on the microstructural, tribological, and corrosion properties of the prepared alloys. Alloying was performed using a mixture of copper and zinc powders with 0vol% and 5vol% of α-Al nanopowder in a satellite ball mill. The results showed that the Cu-Zn solid solution formed after 18 h of mechanical alloying. The mechan-ically alloyed powder was compacted followed by sintering of the obtained green compacts at 750℃ for 30 min. Alumina nanoparticles were uniformly distributed in the matrix of the Cu-Zn alloy. The tribological properties were evaluated by pin-on-disk wear tests, which revealed that, upon the addition of alumina nanoparticles, the coefficient of friction and the wear rate were reduced to 20% and 40%, respectively. The corrosion properties of the samples exposed to a 3.5wt% NaCl solution were studied using the immersion and potentiodynamic polarization methods, which revealed that the addition of alumina nanoparticles reduced the corrosion current of the nanocomposite by 90%.