Dynamics of human adipose lipid turnover in health and metabolic disease

Adipose tissue mass is determined by the storage and removal of triglycerides in adipocytes. Little is known, however, about adipose lipid turnover in humans in health and pathology. To study this in vivo, here we determined lipid age by measuring (14)C derived from above ground nuclear bomb tests in adipocyte lipids. We report that during the average ten-year lifespan of human adipocytes, triglycerides are renewed six times. Lipid age is independent of adipocyte size, is very stable across a wide range of adult ages and does not differ between genders. Adipocyte lipid turnover, however, is strongly related to conditions with disturbed lipid metabolism. In obesity, triglyceride removal rate (lipolysis followed by oxidation) is decreased and the amount of triglycerides stored each year is increased. In contrast, both lipid removal and storage rates are decreased in non-obese patients diagnosed with the most common hereditary form of dyslipidaemia, familial combined hyperlipidaemia. Lipid removal rate is positively correlated with the capacity of adipocytes to break down triglycerides, as assessed through lipolysis, and is inversely related to insulin resistance. Our data support a mechanism in which adipocyte lipid storage and removal have different roles in health and pathology. High storage but low triglyceride removal promotes fat tissue accumulation and obesity. Reduction of both triglyceride storage and removal decreases lipid shunting through adipose tissue and thus promotes dyslipidaemia. We identify adipocyte lipid turnover as a novel target for prevention and treatment of metabolic disease.     

Forensics: age written in teeth by nuclear tests

Establishing the age at death of individuals is an important step in their identification and can be done with high precision up to adolescence by analysis of dentition, but it is more difficult in adults. Here we show that the amount of radiocarbon present in tooth enamel as a result of nuclear bomb testing during 1955-63 is a remarkably accurate indicator of when a person was born. Age is determined to within 1.6 years, whereas the commonly used morphological evaluation of skeletal remains and tooth wear is sensitive to within 5-10 years in adults.     

Preliminary results from Solrad 11 gamma-burst detectors

We present here temporal and 0.2-2 MeV spectral data from two gamma bursts observed on 12 June and 16 August 1976, by detectors on the Solrad 11A and 11B satellites. The 12 June burst showed evidence for structure on time scales down to approximately 10 ms throughout its lifetime, whereas the 16 August burst varied only with characteristic times longer than a few tenths of a second. A search for both slow and fast spectral variability gave negative results. Accurate absolute burst times are, however, not yet available, but since both bursts were also observed by at least one Vela satellite, positions are calculable and will be reported.     

Meteoritic dust from the atmospheric disintegration of a large meteoroid

Much of the mass of most meteoroids entering the Earth's atmosphere is consumed in the process of ablation. Larger meteoroids (> 10 cm), which in some cases reach the ground as meteorites, typically have survival fractions near 1-25 per cent of their initial mass. The fate of the remaining ablated material is unclear, but theory suggests that much of it should recondense through coagulation as nanometre-sized particles. No direct measurements of such meteoric 'smoke' have hitherto been made. Here we report the disintegration of one of the largest meteoroids to have entered the Earth's atmosphere during the past decade, and show that the dominant contribution to the mass of the residual atmospheric aerosol was in the form of micrometre-sized particles. This result is contrary to the usual view that most of the material in large meteoroids is efficiently converted to particles of much smaller size through ablation. Assuming that our observations are of a typical event, we suggest that large meteoroids provide the dominant source of micrometre-sized meteoritic dust at the Earth's surface over long timescales.     

苯酚-硫酸法测定藏木香中多糖含量

采用传统的水煮醇沉法从藏木香中提取可溶性多糖,通过Sevag法脱蛋白后,以葡萄糖为对照品,使用苯酚-硫酸法测定多糖含量.结果表明,在波长486nm处测定吸光度,10-100μg/mL范围内吸光度与被测含量之间具有良好的线性关系,藏木香中多糖的含量为64.37%.     

甘青青兰挥发性成分GC/MS分析

目的：分离鉴定出甘青青兰（Dracocephalum tanguticum Maxim.）挥发油的化学成分.方法：用气相色谱-质谱（GC/MS）联用技术及峰面积归一化法测定各组分的相对含量.结果：共鉴定出23种化合物,占总色谱峰总面积的87.46%.结论：甘青青兰挥发油中的化学成分主要为[-]-反-松香芹乙酯和桉油精,两者分别占总挥发油中化学成分的60.30%和9.31%.     

Cortical control of a prosthetic arm for self-feeding

Arm movement is well represented in populations of neurons recorded from the motor cortex. Cortical activity patterns have been used in the new field of brain-machine interfaces to show how cursors on computer displays can be moved in two- and three-dimensional space. Although the ability to move a cursor can be useful in its own right, this technology could be applied to restore arm and hand function for amputees and paralysed persons. However, the use of cortical signals to control a multi-jointed prosthetic device for direct real-time interaction with the physical environment ('embodiment') has not been demonstrated. Here we describe a system that permits embodied prosthetic control; we show how monkeys (Macaca mulatta) use their motor cortical activity to control a mechanized arm replica in a self-feeding task. In addition to the three dimensions of movement, the subjects' cortical signals also proportionally controlled a gripper on the end of the arm. Owing to the physical interaction between the monkey, the robotic arm and objects in the workspace, this new task presented a higher level of difficulty than previous virtual (cursor-control) experiments. Apart from an example of simple one-dimensional control, previous experiments have lacked physical interaction even in cases where a robotic arm or hand was included in the control loop, because the subjects did not use it to interact with physical objects-an interaction that cannot be fully simulated. This demonstration of multi-degree-of-freedom embodied prosthetic control paves the way towards the development of dexterous prosthetic devices that could ultimately achieve arm and hand function at a near-natural level.     

钢管相贯口变参数变结构建库与数据提取方法研究

零件的批处理和零件库的建立是计算机辅助设计的重要内容之一，以钢管相贯口为例应用UG的几种建库方法，通过分析电子表格、零件族、GRIP编程在变参变结构的复杂零件建库时存在的问题，提出了一种将零件族和GRIP编程相结合的建库方法来建立变参变结构的复杂零件的零件库。