首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   74篇
  免费   1篇
  国内免费   8篇
系统科学   9篇
丛书文集   1篇
综合类   73篇
  2022年   2篇
  2021年   2篇
  2020年   1篇
  2019年   1篇
  2018年   1篇
  2017年   1篇
  2016年   3篇
  2015年   3篇
  2014年   2篇
  2013年   5篇
  2012年   1篇
  2011年   1篇
  2010年   1篇
  2009年   3篇
  2008年   7篇
  2007年   5篇
  2006年   5篇
  2005年   2篇
  2004年   3篇
  2003年   2篇
  2002年   1篇
  2001年   1篇
  2000年   2篇
  1999年   3篇
  1998年   4篇
  1997年   2篇
  1996年   1篇
  1995年   1篇
  1994年   1篇
  1993年   4篇
  1992年   2篇
  1991年   2篇
  1990年   2篇
  1989年   4篇
  1988年   1篇
  1987年   1篇
排序方式: 共有83条查询结果,搜索用时 31 毫秒
1.
This article reports the effects of Sn on the inclusions as well as the mechanical properties and hot workability of ferritic stainless steel. Precipitation phases and inclusions in Sn-bearing ferritic stainless steel were observed, and the relationship between the workability and the microstructure of the steel was established. Energy-dispersive X-ray spectroscopic analysis of the steel reveals that an almost pure Sn phase forms and MnS–Sn compound inclusions appear in the steel with a higher Sn content. Little Sn segregation was observed in grain boundaries and in the areas around sulfide inclusions;however, the presence of Sn does not adversely affect the workability of the steel con-taining 0.4wt%Sn. When the Sn content is 0.1wt%–0.4wt%, Sn improves the tensile strength and the plastic strain ratio and also improves the plasticity with increasing temperature. A mechanism of improving the workability of ferritic stainless steel induced by Sn addition was discussed:the presence of Sn lowers the defect concentration in the ultra-pure ferritic lattice and the good distribution of tin in the lattice overcomes the problem of hot brittleness that occurs in low-carbon steel as a result of Sn segregation.  相似文献   
2.
利用Gleeble3500试验机研究汽车用C-Mn-Al系TRIP钢的高温力学性能,测定了零塑性温度和零强度温度,应用差示扫描量热法测定其相变区间,采用扫描电镜和光学显微镜分析了不同拉伸温度对应的断口宏观形貌及断口附近组织组成.该钢种零塑性温度和零强度温度分别为1425℃和1430℃,第Ⅰ脆性区间为1400℃~熔点,第Ⅲ脆性区间为800~925℃.第Ⅲ脆性区脆化的原因是α铁素体从γ晶界析出,试样从975℃冷却至700℃过程中,随着α铁素体析出比例的增大,断面收缩率先减小后增大.基体α铁素体比例为8.1%时(850℃),断面收缩率降至28.9%;而拉伸温度在800℃以下时,基体α铁素体比例超过16.7%,断面收缩率回升至38.5%以上.该钢种在1275.6℃时开始析出少量粗大的AlN颗粒,但对钢的热塑性没有影响.  相似文献   
3.
A non-cooperative game model based on brittleness entropy is formulated for preventing cascading failure of complex systems.Subsystems of a complex system are mapped to the players of the game.The influence of collapsed subsystems to other subsystems is also taken into account in the definition of payoff function except for their own entropy increase.This influence is named brittleness entropy.Each player has two optional strategies:rational for negative entropy and irrational for negative entropy.The model is designed to identify the players who select an irrational strategy for negative entropy.The players who select the irrational strategy for negative entropy continue to compete for negative entropy after the recovery of ordered state and make other subsystems can' t get enough negative entropy to reduce entropy increase.It leads to cascading failure of the complex system in the end.Genetic algorithm is used to seek the solution of game model,and the simulation result verifies the effectiveness of the proposed model.The model provides a new way to prevent cascading failure of complex systems.  相似文献   
4.
以煤炭截割强变、脆性、破碎性几个特性指标为对象,探索了煤炭截割阻力影响因素,对煤的脆性程度、截割时破碎性进行了评价,为采煤机械的设计计算、选型应用、发挥机器最大效益,提供了理论依据。  相似文献   
5.
对纤维分离点处的麦草碱—乙醇浆,麦草苛性钠浆的打浆性能和纸页物理性能的比较发现:麦草碱—乙醇浆得率高12%(绝对值)左右,浆料易打浆,但相同打浆度下,纸页抗撕裂性能较差、脆裂度较大。脱除其部分残余木素后纸页性能得到改善。不论何种浆,打浆过程中纤维形态结构以及纤维的超分子结构的变化都较大地影响纸页的脆性。  相似文献   
6.
梁益龙  朱茂兰 《贵州科学》2007,25(1):13-16,26
本文研究了GDL-1型高强韧性贝氏体钢,在空冷状态下的回火冲击性能变化以及对应的显微组织和断口金相特征.结果表明,该钢经920 ℃加热空冷后获得条束状过渡形态的贝氏体加少量岛状贝氏体组织.在400 ℃~600 ℃的温度回火,分布于BF条束间的亚稳态残留奥氏体开始大量分解形成沿条束界连续分布的碳化物,在BF条内的高密度位错区也诱导析出碳化物,导致在条束界产生高应力集中而引发准解理和解理开裂,出现不可逆回火脆性,冲击能量显著降低.由于钢中的Si和Mn在原奥氏体晶界偏聚,抑制碳化物析出.在原奥氏体晶界未能沉淀出连续分布的碳化物,因此未见沿晶解理开裂特征,对应的断口金相呈条形准解理和解理的特征,其尺寸分别与BF条和束尺寸相吻合.该材料的不可逆回火脆性出现的温度范围与大多数合金结构钢相比提高约200 ℃.  相似文献   
7.
用余瑞璜的“经验电子理论”的方法及结合能公式,计算了金属间化合物Ni3Al和NiAl的晶体中原子的杂化态电子结构及其结合能,并对这两种材料的脆性问题从电子结构的层次上进行了讨论  相似文献   
8.
针对导致煤矿瓦斯爆炸事故发生的各种致因,运用脆性理论和模糊层次分析法对其进行脆性分析.从事件级别上考虑瓦斯爆炸的脆性过程,分析瓦斯系统内部各个事件之间的脆性联系,从中找出使整个系统崩溃(事故发生)的因素集合,利用模糊层次分析法建立计算煤矿瓦斯爆炸事故中各种致因权重的层次分析模型.根据模型计算所得结果,确定了在瓦斯积聚产生的前提下,火源的4个主要致因权重的重要度排序,由大到小依次为:放炮、机电管理混乱、明火、撞击摩擦火花.对它们进行重点监控,可以很大程度地避免事故发生.该模型及其结果为控制和预防瓦斯爆炸提供了理论依据.  相似文献   
9.
峰后脆性对非均质岩石试样破坏及全部变形的影响   总被引:3,自引:0,他引:3  
在平面应变压缩条件下,采用FLAC模拟峰后脆性对含初始随机材料缺陷的岩样的破坏过程、前兆、声发射及全部变形特征的影响.利用若干FISH函数预置初始随机缺陷,计算全部变形特征,并统计每10个时间步内的破坏单元数.密实的岩石服从莫尔库仑剪破坏与拉破坏复合的破坏准则,破坏之后呈现应变软化-理想塑性行为.缺陷在破坏之后经历理想塑性行为.不同脆性岩石的峰后的应力-轴向应变曲线、应力-侧向应变曲线、侧向应变-轴向应变曲线、体积应变-轴向应变曲线及由侧向应变及轴向应变计算得到的泊松比-轴向应变曲线于应力峰值之前发生分离.由于缺陷的依次破坏,在初始加载阶段之后,计算得到的泊松比随着轴向应变的增加而直线上升,这使侧向应变增加的速度超过轴向应变增加的速度.随着峰后脆性的降低,岩样失稳破坏的前兆变得明显,破坏变得不突然.脆性越强的材料,体积膨胀之后发生应变软化越早;剪切应变集中的位置越少;在硬化阶段及软化阶段,声发射持续的时间越短.  相似文献   
10.
基于适应性Agent图的交通系统脆性研究   总被引:2,自引:0,他引:2  
针对系统脆性的研究,以复杂适应系统和图论为理论基础,提出了Agent图的概念,其中图的每个顶点被看作一个具有适应性的主体。然后将Agent图应用于交通系统脆性的研究,交通网络组成了一个赋权图,网络中各节点作为顶点;考虑到它们之间的交互作用,建立了系统主体崩溃程度的演化规则,进而对交通系统脆性行为进行仿真。  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号