偏硼酸钠与镁和氢反应的硼氢化钠生成

高的氢压和反应温度有利于片硼酸钠与镁和氢反应生成硼氢化钠，但温度接近镁的熔点时不利于硼氢化钠的生成。在反应物中添加铁、镍和钴将加速硼氢化钠的生成，而铜的加入却阻碍硼氢化钠的生成。     

基于PLC现场数据采集与分析

介绍了PLC控制器的可行性分析,阐述了基于PROFIBUS工业以太网数据采集的研究,并提出了基于PLC现场数据采集与分析的方法。     

合金铸铁激光处理的探讨——Ⅱ.激光辐照工艺参数的控制

用热传导方程控制激光辐照温度,建立了一种新回归方程以控制激光辐照硬化深度,选用卡尔丹公式列热传导方程及同归方程联立求解,可得到同时满足一定的硬化深度及表面最高温度双重要求的工艺参数,此种方法可作为激光硬化处理工艺参数的控制或预报,对本合金铸铁的激光硬化处理,其表面温度的下限应大于其熔点温度,即以表面产生微熔的快速冷凝处理为宜,并以选取低功率慢扫描为最佳。     

绝缘栅PMOS的SUPREM—SEDAN联机模拟研究

本文分析及研究了作者对绝缘栅ＰＭＯＳ场效应结构所进行的ＳＵＰＲＥＭ—ＳＥＤＡＮ联机模拟．重点在衬底电阻率（掺杂浓度）与ＭＯＳ结构阈值电压之间的定量关系上得到了与实验完全一致的结果．同时，定量地描述了栅氧层中电离电荷的分布及其行为．揭示了上述效应的机理．     

球电流壳磁场的计算

计算的结果表明，球壳内的磁场是均匀的，可用此方法在一定范围内获得均匀磁场．     

关于田径运动的训练原则分类及其相关内涵探析

从田径运动训练的实践出发，采用文献资料法和归纳法，在广泛研究国内外田径运动训练专家有关田径训练的论述基础上，根据各原则的性质，按照由宏观抽象，到微观具体的思路，将其划分为田径运动的基本训练，专项训练和方法学3类训练原则加以探讨，并具体分析了各原则的内涵。     

The crystal-like anatomical uniformity of the striate cortex

The visual field is topographically mapped onto the primary visual cortex (V1), forming a retinotopic map which is far more detailed for the foveal regions than for the periphery. We found that receptive field (RF) size in monkey V1 increases with eccentricity, and that a 1—2 m² V1 region contains roughly a complete set of machinery necessary to analyze a visual-field area whose size is about that of the RFs of the cells. This allows V1 to be anatomically uniform, and is in sharp contrast with the retina.     

Joint Strength with Soldering of Al2O3 Ceramics After Ni-P Chemical Plating

Ni-P alloy was chemically plated on Al2O3 ceramics to produce uniform alloy coatings at temperatures below 70~C. Cu metal was electroplated onto the Ni-P coating to facilitate the soldering and shorten the chemical plating time. Then, the electroplated ceramic specimens were soldered with 60 wt.% Sn-40 wt.% Pb solder in active colophony. The highest shear strength was acquired after the heat treatment at 170℃ for 15 min. The joint fractures mostly propagated along the interface between the ceramics and the Ni-P coating, with some fracture in both the ceramics and the Ni-P coating near the interface and some along the interface between the Cu and Ni-P coatings. The results show that ceramic surface roughness and the chemical plating parameters influence the coating quality, and that suitable heat treatment before the soldering also improves the adhesion between the ceramics and Ni-P coatings, thus strengthening the joints.     

收尘极板上沉降粉尘粘结性能研究

振打清灰效果不好，严重影响电除尘器的除尘效率和使用范围，而影响振打清灰效果的最主要因素是沉降粉体的粘结力。通过建立数学模型从微观的角度推导出粉尘之间各种粘结力的理论计算公式。分析了比电阻、外加电场和粉尘含水率等因素对粉尘粘结力的影响。在实验中，模拟电除尘器中的静电场，测出在不同外加电场下粉尘粘结力的大小，定量的反应了外加电场对粉尘粘结性能的影响。